Nortel Networks M3110 - Manual (Page 38)

Page 38 of 504 Attendant consoles
553-3001-367 Standard 3.00 August 2005
Figure 4
Removing the top cover
7 Remove the knockout section on the back of the attendant console (see
Figure 5 on
page 39 ) with a small screwdriver or similar tool. Remove any
remnants of the breakaway tags.
8 Feed the flat ribbon cable for the Busy Lamp Field/Console Graphics
Module (BLF/CGM) through the knockout hole in the base of the
attendant console.
9 Hold the BLF/CGM unit over the console in a vertical position, ensuring
that the two locators on the bottom bracket of the BLF/CGM are located
in the knockout hole.
Remove flat cable
Top cover
553-AAA1719.EPS
Base