Nortel Networks M3110 - Manual (Page 377)

Appendix C: Meridian Modular Telephones add-on modules installation Page 377 of 504
Telephones and Consoles Description, Installation, and Operation
Procedure 67
Installing and removing the
Analog Terminal Adapter
1 When the ATA is installed, the System Administrator must activate the
Flexible Voice and Data Feature by configuring LD 11.
2 To Activate the Flexible Voice and Data Feature, use the following chart
to configure LD 11 (for more detailed information, refer to Software Input/
Output: Administration (553-3001-311)).
CAUTION WITH ESDS DEVICES
Before handling internal telephone components,
discharge static electricity from hands and tools by
touching any grounded metal surface or conductor.
Table 66:
Flexible Voice and Data feature configuration (Part 1 of 2)
Prompt Response Description
REQ: NEW/CHG New or change
TYPE: aaaa Telephone type, where aaaa = 2006, 2008, 2016, or 2616
TN Terminal Number, where u = 16-31
l s c u Format for Large System and CS 1000E system, and Media
Gateway 1000E, where l = loop, s = shelf, c = card, u = unit.
c u Format for Small System, CS 1000S system, Media Gateway
1000B, and Media Gateway 1000T, where c = card and u = unit.
CLS FLXA Flexible voice/data allowed. This Class of Service can only be
assigned to 2006, 2008, 2016, 2216 or 2617 sets. When
configured to CLS=FLXA
VCE (FLXD) = Flexible voice/data denied. Voice Class of Service
(VCE) can be assigned to the upper TN unit (16-31) and Data
class of Service (DTA) can be assigned to the lower TN (0-15). A
Single Call Ringing (SCR) key can be designated a Data Mode
(DTNK) key.