Nlynx ETU400 - Manual (Page 141)

ETU400 User Guide 011603 10-11
DSPSTSMSG Displays program status messages during the execution of the
command. The default is *YES. To turn the messages off, enter
*NO.
FROM3XB Notes
When you specify file translation with this command, the AS/400 file
(FRMFILE) is read by the translate program. After the program translates
the data, it writes the translated data into a workfile that is created
for this purpose (PCTTOWORK in QTEMP). It is this workfile that will then
be transferred to the micro.
If the sequence number and date fields (like those of a source physical
file) exist in the qualified file, these fields can be stripped during
the ASCII-to-EBCDIC translation process by specifying STRIP (*YES).
If the data was translated prior to using the FROM3XB command, with the
XLATETO or PRTXTOPC commands, you must code the FROM3XB parameters STRIP
and TRANSLATE as follows:
strip(*no), translate(*no)