Nlynx ETU400 - Manual (Page 142)

ETU400 User Guide 011603 10-12
PCFROMPC Command
Parameter description Parameter name Parameter values
Qualified file name QFNAME micro file name
Transfer from which
micro?
MICLIST1 Device name(s) of
one or more
micros.
Transfer to which micro? MICLIST2 *REQUESTER device
name of target
micro
Save request definition? SAVRQS *YES or *NO
Request name Name
Display status message? DSPSTSMSG *YES or *NO
The PCFROMPC command transfers a file from one or more microcomputers to
a single microcomputer. All micros involved in a file transfer must be of
the same platform, either Mac or DOS-based PC, but not both.
NOTE: Before using PCFROMPC to transfer multiple files to a single micro,
review Transferring Files With PCFROMPC and PWRTO3XB in Chapter 9 in
order to minimize the risk of copying over previously transferred files.
QFNAME1 The name of the micro file to be transferred. If you are
transferring a file from multiple micros, the file name,
including the path name, must be identical on each micro. For
additional information, see About Microcomputer Files in
Chapter 3.
MICLST1 The device name of the source micro(s). To transfer a file
from more than one micro, enter the device name of each. (You
must be authorized to use each device you specify in the
MICLIST1 parameter. If you can sign on to the device, then
you are authorized to use it.)
Enter a plus sign ( ) here and press ENTER to display
multiple prompts in which to enter the device names.
Each micro from which you transfer data must be powered on,
have emulation loaded, and have the AS/400 sign-on screen
displayed.