Nlynx ETU400 - Manual (Page 161)

ETU400 User Guide 011603 10-31
SAVRQS Saves the current request definition so it can be reused at a
later time. The request definition is this completed
PWRFROM3XB command with the parameter values as you have
specified them. The default is *NO. To save the request
definition, specify *YES and enter the request name you
desire.
Request name The name of the SAVRQS request definition. The
request name can be up to ten characters long.
(To recall the saved request, use the ETU command
VWSAVRQS.)
NOTE: When saving a PWRFROM3XB command in which the Record
Selection parameter list is used, special values should not be used for
the Comparison prompt.
TRANSFILE The file name of the translation table file to be used when a
translation is specified. The default translate file name is
TRANSLATE. The file TRANSLATE is in the library containing
the ETU programs.
Mac Users: There are two files you can use. If you use the default file
(TRANSLATE), the member names have an M on the end of the name (for
example, ETOA1M). The Mac translation members are also shipped in a file
called MACTAB. The members in this file do not have the M at the end of
the name (for example, ETOA1).
Library name The name of library containing the translation
table file. The default is *LIBL, which searches
all libraries in the user's library list.
Member name The TRANSLATE member name. The default name is
ETOA1, an EBCDIC-to-ASCII table supplied with
ETU.
FLDDEFFILE The name of the source physical file containing the
data description specifications (DDS) or RPG source
file containing F and I specifications. Use the
default, *NONE, if the file being transferred was
previously defined with DDS.
Library name The library containing the source physical file
specified in FLDDEFFILE. The default, *LIBL,
searches all libraries in the user's library
list.
Member name The source physical file member containing the
DDS or F and I. The default, *FILE, uses the
member with the same name as the FLDDEFFILE
source file.
RECL The record length of the translation work file. Valid entries
are:
*FILE The record length of the FRMFILE file is used.
record The actual record length for the translation work
file.