Nlynx ETU400 - Manual (Page 253)

ETU400 User Guide 011603 E-15
CPF MESSAGES:
These are the same as User Failures, except it was call by a program. Call Program Fault.
PROBLEM
Getting “CPF4101 File &2 in library &3 not found or inline data file missing” when doing a file
transfer.
CAUSE:
The file was not opened. The reason code is below. The reason codes and their meanings are as
follows:
01 - The library does not exist.
02 - The file does not exist. The library does exist.
03 - The file does not exist. The library specified as *LIBL.
04 - The file was saved with storage freed.
07 - An inline data file does not exist.
08 - A diskette file with SPOOL (*YES) is being opened for a read operation and an inline data file
does not exist.
10 - The file on the remote system does not exist.
11 - The library on the remote system does not exist.
SOLUTION:
When you get this error, move your cursor on top of the message and hit F1 to get more details.
Do one of the following based on the reason code shown, and try the request again:
01 - Change the library name with an appropriate override files command, or create a library
(CRTLIB command) and a file with the appropriate name.
02 - Change the file name, the library name, or both the file name and library name with an
appropriate override file command.
03 - Add the library to the library list (ADDLIBLE command) or change the file name, the library
name, or both the file name and library name with an appropriate override file command.
04 - Restore the file (RSTOBJ command) or change the file name, the library name, or both the
file name and library name with an appropriate override file command.
07 - Add an inline data file (DATA command) or change the file name, the library name, or both
the file name and library name with an appropriate override file command.
08 - Specify the *NO value for the SPOOL parameter on the Override Diskette File (OVRDKTF)
command or add an inline data file (DATA command) or change the file name, the library
name, or both the file name and library name with an appropriate override file command.
10 - Change the file name in the distributed data management (DDM) file with a Change DDM
File (CHGDDMF) command or use the necessary procedures to make the file exist on the
remote system.
11 - Change the library name in the distributed data management (DDM) file with a Change