Nlynx ETU400 - Manual (Page 245)

ETU400 User Guide 011603 E-7
PROBLEM:
"USR4001 The PC disk/diskette is full - Transfer ended."
CAUSE:
The disk or diskette to which you are transferring became full during the transfer causing the
transfer to end. When transferring a file to the micro with ETU, the size of the file being transferred
may not be greater than the capacity of the disk or diskette receiving the file.
SOLUTION:
Specify a different drive with a greater capacity.
PROBLEM:
"USR5255 Invalid PC file name or no space for a new directory entry."
Invalid PC file name -- or -- No space for a new director entry.
CAUSE:
The file name specified for the PC file is not a valid file name. If a file with that name exists and is
open by another application, it can cause this.
The file may already exist and have the Read-only attribute set in it’s Properties. Right-click on the
file and select Properties to check this.
File names must follow the naming conventions of the system you are using. See Chapter 3, 'using
ETU" for more information about microcomputer file names.
SOLUTION:
If a file with that name exists and is open by another application, close it. Retry the transfer using a
new file name.
CAUSE:
The disk or diskette you specified is full and the transfer operation did not begin. ETU will not initiate
a transfer operation to a full disk or diskette.
SOLUTION:
Replace the diskette or specify a different disk drive.
CAUSE:
Virus protection software prevents the writing.
SOLUTION:
Disable the Virus protection software or the feature that prevents disk writing.