Nlynx ETU400 - Manual (Page 177)

ETU400 User Guide 011603 10-47
TESTB Command
Parameter description Parameter name Parameter values
Qualified file name QFNAME micro file name
Notify operator? NOTIFY *YES
*NO
Starting position in LDA POS no default
1-1012
Display status messages? DSPSTSMSG *YES
*NO
The TESTB command tests for the existence of a file on the micro. The
result of the test is returned in a data area (PCTDTAARA) in QTEMP for
later use. If you specify NOTIFY (*YES), you will be notified if the file
exists via a completion message.
QFNAME The name of the micro file to be tested. For additional
information, see About Microcomputer Files in Chapter 3.
NOTIFY Determines whether a message about the existence of the file
is to be sent to the display
*YES Always send message (default).
*NO Do not send any message.
*LDA Do not send any message but put result in
LDA(convenience to S/36 users).
POS The starting position in the LDA for the result. Use this
parameter only with NOTIFY (*LDA).
DSPSTSMSG Displays program status messages during the execution of the
command. The default is *YES. To turn the messages off, enter
*NO.