Nlynx ETU400 - Manual (Page 257)

ETU400 User Guide 011603 E-19
SYS MESSAGES:
These are not ETU messages. These are System Messages. The exact meaning could probably be
traced using F1 on the error message.
PROBLEM
He is doing FROM3X on a file. Getting an error message:
“SYS1185 Error: User One Member INVOICE file INVOICE in library QS36 not found”.
CAUSE:
The Member name is still set to *FILE. This makes ETU look for a member with the name INVOICE
in this case. .
SOLUTION:
Change the Member name to *ALL.
PROBLEM
Running ETU 4.108 on an AS/400 in SSP emulation mode, and using the old pctran commands.
After MENU ETU36 brings up the menu, when you enter option 13, you get the following:
TRNSMT02
DELETE procedure is running
BLDFILE procedure is running
TRANSMIT FILE BEING CREATED
*** ERROR *** see statement:
// LOAD PCRCB2
SYS1235 Options ( 3)
Program PCRCB2 in LOAD statement was not found.
CAUSE:
The ETU library is not correctly loaded.
SOLUTION:
1) Make certain that ETU is in the library it was installed in. You can not install it and move it. There
are CL's that compile with the install library name. If it was moved, you will either have to move it
back or reinstall.
2) Make certain the ETU library list entries are loaded. ADDLIBLE libname
3) You may need to remove library list entries that are incorrect. RMVLIBLE libname
4) If Use the newer commands of MENU ETU36 and try it the manual first. The command line
second, and OCL's third.
5) If it's the S/36 ENVIRONMENT the files will usually be found in libraryQS36F (unless someone
altered the default S/36EE file library – check with command DSPS36 and look at S/36
Environment Variables).