Nortel Networks 6.1 - Manual (Page 188)

188 / Using the Hospitality features
Compact ICS 6.1 System Coordinator Guide P0603544 02
3. Press
ЫЬЯЭЯ (ADMIN). The display shows
Terminals&Sets.
4. Press ‘ until the display shows Hospitality.
5. At the Hospitality heading, press ≠ until Service time
displays.
6. Press ≠. Hour: 00 displays.
7. Press CHANGE and enter the hour (00 to 23).
If the number is less than 13, the display shows AM. Press CHANGE to select
PM, if required. Press OK to accept.
8. Press ≠. Minutes: 00 displays.
9. Press CHANGE and enter the minutes (00 to 59).
Using the room/set programming
This section describes how the room occupancy and room condition
settings are used.
Setting dialing filters by room state
1. Press
²¡àá.
2. Enter the Desk admin password if you are prompted for a password.
The set displays: Oc of rm#::
3. Enter the room number and press OK.
The set displays rrrrr:Vacant.
4. Press the CHANGE display key and select the required status for the
room set.
5. To program other rooms, press the FIND or NEXT display key and
return to step 3.
6. Press
¨ to exit.
Note: Setting the room state to Vacant cancels any outstanding alarms.