Nortel Networks 6.1 - Manual (Page 52)

52 / Answering calls
Compact ICS 6.1 System Coordinator Guide P0603544 02
• KIM multi-module cold start
If you want to cold start all the KIMs
attached to your telephone,
simultaneously press the top two
buttons on the upper button set, and
the bottom two buttons on the lower
button set, as shown in the following
diagram.
Customizing your KIM module
You can move external lines, target lines or hunt group appearances onto
the eKIM by using
²¥¡Ú. See ‘‘Moving line buttons’’ on page
162.
Any of the buttons on your KIM that do not select lines can be programmed
to dial internal or external numbers automatically. You also still can
program features directly onto KIM buttons. Refer to ‘‘Time savers for
making calls’’ on page 97 and ‘‘Customizing your telephone’’ on page 147
for information about programming memory buttons.
eKIM button programming for CAP
Any lines and target lines assigned to the T7316E, which overflow to the
eKIM, must be assigned by your installer. You can, however, use the
Coordinator password to assign the telephone to the hunt groups for which
you want to provide an appearance. Refer to ‘‘Programming Hunt Groups’’
on page 171 for information about programming hunt group appearances.
Designating features or autodial numbers to the eKIM buttons, can be
programmed using the Button progrmng, which is found under User
Preferences under Terminals&Sets.
You need the programming template found at the front of this guide.
1. Press
²¥¥ЫЯЯЬЭЭ.
2. Press
ЫЬЯЭЯ (the default System Coordinator password).
Terminals&Sets displays.