Nortel Networks 6.1 - Manual (Page 255)

Common feature displays / 255
P0603544 02 Compact ICS 6.1 System Coordinator Guide
You are receiving a priority call. If you are on
another call, inform the person you are speaking
to that the call is about to be put on hold. Press
the flashing line indicator of the priority call or
wait until the call connects automatically (in eight
seconds). The priority call goes through when
you hear the next beep. Your active call is placed
on Exclusive Hold. It is reconnected
automatically when the priority call ends (unless
you transfer the priority call, in which case you
must press the line button of your original call to
reconnect). Use DND (
²¡Þ
) or press
BLOCK to reject a priority call.
You have no free line buttons on which to receive
a call. Release one of your current calls and try
again to answer the incoming call.
You have received a Ring Again offer for a line
pool. Press
the flashing internal line button or YES
to use the line pool. On M7100 or T7100
telephones, just lift the handset. Otherwise,
press
NO or wait 30 seconds for the Ring Again
offer to expire.
You cannot program a feature button while you
are on a call.
You have tried to use a feature while you were on
a call or had calls on hold. Release the call or
calls, before using the feature.
The line is in use. Make the call using normal
methods or wait until the line is free.
You have tried to make, receive or pick up a call
when no line button was available. Some
features require you to have a button free.
Releasing calls can free up line buttons.
The feature you tried to use requires you to be on
an active call at your telephone. This display also
appears when information about a call has been
cleared by a system reset.
Priority> 21
BLOCK
Release a call
Use line pool?
YES
NO
Hold or release
Release calls
Line in use
No button free
Make calls first