Raritan Computer CC-SG - Manual (Page 155)

C HAPTER 11: S YSTEM M AINTENANCE 141
To Delete a backup
1. From the Available Backups table, select the backup you want to delete.
2. Click Delete. A confirmation dialog appears.
3. Click OK to delete the backup from the CC-SG system or Cancel to exit without deleting.
Once deleted, the file backup file will be removed from the CC-SG.
Note: Saving and restoring can be used to move a backup from one CC-SG unit to another.
Saving and deleting can be used to maintain a secure archive of CC-SG backups without storing
the full archive on the system.
Reset CC-SG
Use the Reset CommandCenter command to purge CC-SG database data. This will not reset
system configuration data, such as the IP address of CC-SG. The following actions will be taken:
reset CC-SG database, reset SNMP configuration, reset to default firmware, load default
firmware into CC-SG database, and reset the Diagnostic Console to default values.
1. On the System Maintenance menu, click Reset.
Figure 139 Reset CC-SG Screen
2. Type your CC-SG password.
3. Either accept the current Broadcast message or edit to create one of your own.
4. Type the number of minutes, from 0-60, that CC-SG will wait before performing the reset
operation in Reset after (min). Default is 0, which will reset the CC-SG unit immediately.
5. Click OK to reset your CC-SG unit. A success message will appear to confirm the reset.
Important: Using the Reset command will purge the database of CC-SG. All
Devices, Nodes, Ports, and Users will be removed. Authentication is also reset
to the Local DB. You should back up CC-SG before using Reset.
Restart CC-SG
The restart command is used to restart the CC-SG software. Restarting CC-SG will log all active
users out of CC-SG.
Note: Restart will not cycle power to the CC-SG. To perform a full reboot you will need to access
the Diagnostic Console or the power switch on the unit itself.
1. On the System Maintenance menu, click Restart. The Restart CommandCenter screen
appears.
Figure 140 Restart Screen