Raritan Computer CC-SG - Manual (Page 81)

C HAPTER 6: C ONFIGURING N ODES AND N ODE G ROUPS 67
Add Node
To add a new node to CC-SG:
1. Click the Nodes tab.
2. On the Nodes menu, click Add Node. The Node Profile screen appears.
Figure 65 Add Node Screen
3. Type a name for the node in the Node Name field. All node names in CC-SG must be unique.
4. Optionally, type a short description for this node under the Description field.
5. You must configure at least one interface. Click Add in the Interfaces area of the Add Node
screen to add an interface. Please refer to the Add an Interface section below for additional
information on this procedure.
6. A list of Categories and Elements can be configured to better describe and organize this
node. Please refer to Chapter 4: Creating Associations for additional information.
• For each Category listed, click the Element drop-down menu, and then select the
element you want to apply to the node from the list. Select the blank item in the Element
field for each Category you do not want to use.
• If you do not see the Category or Element values you want to use, you can add more
through the Associations menu. Please refer to Chapter 4: Creating Associations for
additional information.
7. Click OK to save the node. The node will be added to the node list.
Add an Interface
1. For an existing node: click the Nodes tab, and then select the node to which you want to add
an interface. In the Node Profile screen that appears, click Add in the Interfaces section.
If you are adding a new node: click Add in the Interfaces section of the Add Node screen.
The Add Interface Window appears.