Raritan Computer CC-SG - Manual (Page 50)

36 C OMMAND C ENTER S ECURE G ATEWAY A DMINISTRATOR G UIDE
Add a Device
Devices must be added to CC-SG before you can configure ports or add Out-of-Band interfaces
to Nodes through those ports. Add Device is used to add devices whose properties you know and
can provide to CC-SG.
To add a device to CC-SG:
10. On the Devices menu, click Device Manager, and then click Add Device. The Add Device
screen appears.
Figure 30 Add Device Screen
11. Click the Device Type drop-down arrow and then select the type of device you are adding
from the list. If you select PowerStrip, you will see a slightly different Add Device screen.
Adding a KVM or Serial Device
12. Type a name for the device in the Device name field.
13. Type the IP Address or Hostname of the device in the Device IP or Hostname field. For
hostname rules, refer to Terminology/Acronyms in Chapter 1: Introduction.
14. Type the TCP communication port used to communicate with the device in the TCP port
number field. The default port number for most Raritan devices is 5000.
15. Type the name used to log onto this device in the Username field. If you followed the
Raritan Digital Solutions Deployment Guide to prepare your devices to add to CC-SG,
type the username for the CC-SG Administrative User you configured on the device.
16. Type the password needed to access this device in the Password field. If you followed the
Raritan Digital Solutions Deployment Guide to prepare your devices to add to CC-SG,
type the password for the CC-SG Administrative User you configured on the device.
17. Type the time (in seconds) that should elapse before timeout between the new device and CC-
SG in the Heartbeat timeout (sec) field.
18. If applicable, check Allowed under Local Access if you want to allow users to have direct
access to this device while it is managed by CC-SG.
19. Optionally, type a short description of this device in the Description field.
20. Check Configure all ports if you want to automatically add all ports on this device to the
Devices tab, and create a Node for each port on this device in the Nodes tab. Corresponding
nodes and ports will be configured with matching names. If checked when the device is
added, a new node will be created for each port, and an out-of-band interface will be created
for that node.