Raritan Computer CC-SG - Manual (Page 89)

C HAPTER 6: C ONFIGURING N ODES AND N ODE G ROUPS 75
5. Select an existing node in the Interfaces table, and then click Edit or Delete to edit or delete
that interface from the node. Please refer to the Edit an Interface or Delete an Interface
section above for additional information on this procedure.
6. A list of Categories and Elements can be configured to better describe and organize this
node. A category is a way to classify a node and an element is a specific value for that
classification. For example, if the node represents a PC belonging to the engineering
department, for a category called Department, one could select an element called Engineering.
To configure a Categories and Elements for the node:
a. For each Category in the list you want to assign a value to double-click the Element
field next to it. The field turns into a drop-down menu.
b. Click the drop-down menu and select the desired Element value. Select None if you do
not want to use this Category.
If you do not see the Category or Element values you desire, more can be added through the
Associations menu. Please refer to Chapter 4: Creating Associations for additional
information on creating Categories and Elements.
7. Click OK when you are done configuring the node.
Delete a Node
Deleting a node will remove it from the Nodes List. The node will no longer be available for
users to access and it will lose all of its previous interfaces and associations.
To delete a node:
1. Click the Nodes tab to the left.
2. Right-click the node you want to delete and select Delete Node. The Delete Node screen
appears displaying the name of the selected node.
Figure 73 Deleting a Node
3. Click OK to delete the node or Cancel to exit without deleting.