Raritan Computer CC-SG - Manual (Page 52)

38 C OMMAND C ENTER S ECURE G ATEWAY A DMINISTRATOR G UIDE
4. Click the Number of Outlets drop-down menu and select the number of outlets this Power
Strip contains.
5. Click the Managing Device drop-down menu, and then select the device that you will use to
manage this power strip from the list.
6. Click the Managing Port drop-down menu, and then select the port on the managing device
to which this power strip is connected.
7. Optionally, type a short description of this Power Strip in the Description field
8. Check Configure All Outlets if you want to automatically add each outlet on this device to
the Devices tab.
9. A list of Categories and Elements can be configured to better describe and organize this
Power Strip and the nodes connected to it. Please refer to Chapter 4: Creating Associations
for additional information.
• For each Category listed, click the Element drop-down menu, and then select the
element you want to apply to the device from the list. Select the blank item in the
Element field for each Category you do not want to use.
If you do not see the Category or Element values you want to use, you can add more through
the Associations menu. Please refer to Chapter 4: Creating Associations for additional
information.
10. When you are done configuring this device, click Apply to add this device and open a new
blank Add Device screen that allows you to continue adding devices. Or, click OK to add this
Power Strip without continuing to a new Add Device screen.
Discover Devices
Discover Devices initiates a search for all devices on your network. The search can automatically
detect all new and previously existing Raritan devices on your network, including Paragon II
System Controller, IP-Reach, Dominion KX, Dominion KX101, Dominion KSX, Dominion SX,
and eRIC units. After discovering the devices, you may add them to CC-SG if they are not
already managed.
1. On the Devices menu, click Discover Devices. The Discover Devices screen appears.
Figure 32 Discover Devices Screen
2. Type the range of IP addresses where you expect to find the devices in the From Address
and To Address fields. The To Address should be larger than the From Address. Specify a
mask to apply to the range. If a mask is not specified, then a broadcast address of
255.255.255.255 is sent, which broadcasts to all local networks. To discover devices across
subnets, you must specify a mask.
3. Check Broadcast discovery if searching for devices on the same subnet on which CC-SG
resides. Uncheck Broadcast discovery to discover devices across different subnets.