Quantum Data 801GC - Manual (Page 167)

6-41
Pressing the Exit button leaves the sequence editor
and returns to the sequence knob directory editor.
If there are any unsaved changes, you will be asked
if you want to save your work before exiting.
Running a Sequence
The 801G* will power-up in the sequence mode under
the following conditions:
• One of the sequence files stored in the 801G*
is programmed as the “Power-on” sequence.
The previous section on the sequence editor
has information on how to do this
• None of the front panel buttons are held in
when the 801G* is powered up.
Step #1 of the “Power-on” sequence is selected at
the end of the power-up cycle. The top row of the
the LCD window will show the name of the sequence
and the bottom row will show the step number.
The lower “Image” knob is used to move forward
and backward through the steps in the sequence.
A manual mode sequence can be set to continuously
cycle
through all the steps, by rotating the bottom
knob a full turn clockwise beyond the last step A
message on the LCD will confirm that the cycle is
running. The cycle is stopped by rotating the bot-
tom knob counter-clockwise.
❖ The 801G* will remember if the sequence was in
continuous cycle on power down. If so, it will
continuous cycle on power on.
The upper “Format” knob is used to load other se-
quence files. The list of files that can be selected by
the knob is modified using the sequence knob di-
rectory editor in the programming mode.
❖ Caution: A programmer can make any sequence
the “Power-on” sequence without having it ap-
pear on the sequence knob directory. The 801G*