Quantum Data 801GC - Manual (Page 331)

8-23
9450 Invalid format location
This occurs during FMTR command when the integrity of
the data stored in the specified format memory location is
corrupt.
■
Delete the format from nonvolatile RAM using the
YANK command. Then recreate and save the format.
A corrupted format in EPROM requires at least the
replacement of the firmware EPROM set.
9451 Bad location for format, failed verify
This occurs during FMTV command and FMTV? query when
you attempt to verify data integrity at an invalid location.
■
Use a range of -1 through -nn for permanent formats
in EPROM or 1 through 300 for formats saved in
nonvolatile RAM.
9452 Bad location for format verify
This occurs during a FMTZ? query when you try to determine
if an invalid location has been erased.
■
Use a range of 1 through 300 for formats saved in
nonvolatile RAM.
9453 Can’t change EPROM contents
This occurs during FMTW or FMTZ commands when you
try to overwrite or zero out an EPROM format.
■
Use a range of 1 through 300 for formats saved in
nonvolatile RAM.
9454 Bad location for format erase
This occurs during FMTE command when you try to access
an invalid format memory location.
■
Use a range of 1 through 300 for formats saved in
nonvolatile RAM.
9456 Bad location for format read/write
This occurs during FMTR or FMTW commands when you
try to read or write to an invalid format memory location.
■
Use a range of -1 through -nn for permanent formats
in EPROM or 1 through 300 for formats saved in
nonvolatile RAM. Use a range of from 1 through 300
to save formats in nonvolatile RAM with the FMTW
command.