Quantum Data 801GC - Manual (Page 307)

7-3
• See Chapter 2 of this manual for infor-
mation on using the 801G* in the nor-
mal operating mode.
• See the “Programming” chapter for
information on setting-up and running
the 801G* in the test sequence mode.
If any other messages appear, it will be be-
cause one or more problems were found
during the generator’s power-on self test.
• See "System Error Messages" in Chap-
ter 8.
If the power light fails to come on when the
power switch is turned on, first check your
power connection and line voltage selection,
then check the fuse.
• See "AC Line Connection" in Chapter
5.
P o w e r - o n a n d C o m p u t e r I n t e r f a c i n g
Unit will not
power-on
Computer Interfacing
Information on troubleshooting problems related to
the RS-232 and IEEE-488 ports can be found in the
“Programming” chapter.
❖ Please note that leaving any unused equipment
connected to the 801G*’s ports may cause the
front panel display and controls to hang. If this
should happen, disconnect the equipment and
cycle the power on the 801G*.
Error message at
power-on