Quantum Data 801GC - Manual (Page 324)

8-16 Chapter 8: Error Messages Model 801GC, 801GF & 801GX¥Rev. A
2706 Vertical physical size too small
The physical vertical size must be greater than zero.
■
Change the vertical physical size to a positive, nonzero
value.
2714 Pedestal swing out of range
The analog video blanking pedestal cannot be less than 0
IRE (%) or more than 100 IRE (%).
■
Change the value of Pedestal level to be greater than
or equal to 0 and less than or equal to 100 IRE (%).
2715 Gamma correction out of range
The firmware does not support gamma correction factors
that are less than 0.1 or greater than 10.0.
■
Change the value of Gamma to be greater than or
equal to 0.1 and less than or equal to 10.0.
2716 Analog video swing out of range
The hardware does not support peak-to-peak analog video
swings that are less than 0 or greater than 1.000 volts. The
swing does not include any composite sync levels that may
be added.
■
Change the Video swing to be greater than or equal
to 0 and less than or equal to 1.000 volts.
2717 Sync swing out of range
The hardware does not support peak-to-peak analog
composite sync swings that are less than 0 or greater than
0.400 volts.
■
Change the Sync swing to be greater than or equal to
0 and less than or equal to 0.400 volts.
2719 Video swing calibration out of range
One or more of the analog video swing calibration factors
are out of range. These parameters are not actually part of
a Format that is stored in memory. They are system level
parameters that affect how all analog Formats are read from
memory and into the hardware. The parameter settings are
maintained while the 801GP is turned off.
■
Re-initialize your generator’s memory.
■
Contact Quantum Data for further assistance.