Quantum Data 801GC - Manual (Page 286)

6-160 Chapter 6: Programming Model 801GC, 801GF & 801GX¥Rev. A
SEQA SEQuence save As
Classification: Sequence memory management
Command Syntax: SEQA <name>
Limits: <name> = a valid MS-DOS filename
(8 characters minus any extension)
Query Syntax: None
Description: The SEQA command saves the current contents of the sequence
edit buffer using the given name.
Other Required Cmds: None
Example: S E Q A M Y _ S E Q / / S a v e w i t h t h e n a m e
/ / " M Y _ S E Q "
SEQB SEQuence editing Begin
Classification: Sequence editor control
Command Syntax: SEQB
Description: The SEQB command marks the beginning of a sequence editing
session. This command does nothing in the current firmware
version, but is used for compatibility with future versions of
firmware.
Other Required Cmds: Either a SEQL command to load an existing sequence or a SEQN
command to create a new sequence. SEQE when ending the
editing session.
Example: S E Q N / / I n i t i a l i z e s e q u e n c e e d i t b u f f e r
S E Q B / / S t a r t s e q u e n c e e d i t i n g s e s s i o n
/ / O n e o r m o r e s e q u e n c e e d i t i n g
/ / c o m m a n d s
/ / . . .
S E Q E / / E n d s e q u e n c e e d i t i n g s e s s i o n
SEQE SEQuence editing End
Classification: Sequence editor control
Command Syntax: SEQE
Query Syntax: None
Description: The SEQE command marks the end of a sequence editing session.
This command does nothing in the current firmware version,
but is used for compatibility with future versions of firmware.
Other Required Cmds: SEQB when starting the editing session. Use SEQA or SEQS to
save changes.
Example: S E Q B / / S t a r t s e q u e n c e e d i t i n g s e s s i o n
/ / O n e o r m o r e s e q u e n c e e d i t i n g
/ / c o m m a n d s
/ / . . .
S E Q E / / E n d s e q u e n c e e d i t i n g s e s s i o n
S E Q A M Y S E Q _ 0 2 / / S a v e e d i t e d s e q u e n c e a s
/ / M Y S E Q _ 0 2