Quantum Data 801GC - Manual (Page 201)

6-75
Command Language
All of the commands you can only though the IEEE-
488 port on the 801G* generator are listed in a pre-
vious section. All of the commands you can use with
either the RS-232 or IEEE-488 port on the 801G*
generator are listed in this in this section. They’re
listed two ways. The Command and Query Finder
section groups them by function. For example, all
the commands used to change format parameter are
listed under one heading. This is followed by a
straight alphabetical listing of the commands. This
listing also contains descriptions and expected pa-
rameters.
Command and Query Finder
This listing shows all of the commands and queries
supported by the current version of firmware. Each
command or query will be listed under one or more
of the following headings:
■
Format Parameter Settings
■
Format Error Checking
■
Format Editor Control
■
Format Memory Management
■
Custom Image Drawing Primitives
■
Custom Image Editor Control
■
Image Memory Management
■
Sequence Editor Control
■
Sequence Memory Management
■
Directory Editor Control
■
Directory Memory Management
■
System Parameter Settings
■
Direct Processor Control