Quantum Data 801GC - Manual (Page 276)

6-150 Chapter 6: Programming Model 801GC, 801GF & 801GX¥Rev. A
MODE communications MODE
Classification: System parameter setting
Command Syntax: MODE <baud> [<parity> [<data > [<stop> [<handshake> [<
protocol>]]]]]
Limits: <baud rate>
300, 600, 1200, 2400, 4800, 9600, 19200 or 38400 bits/
sec
<parity>
N = None, E = Even or O = Odd
<# data bits>
7 or 8
<# stop bits>
1 or 2
<handshake>
N = None, S = Software (XON/XOFF) or
H = Hardware (CTS/RTS)
< protocol >
N = None, Y=Y-Modem
Query Syntax: MODE?
Query Response: <baud> <parity> <data > <stop> <handshake> < protocol>
or
<ISA addr>
Description: The MODE command is normally used to set the serial port
communications parameters of a stand-alone model generator.
The changes take effect as soon as the command is entered. The
command has no affect on the ISA addressing configuration of
the -ISA model generators. The MODE? query returns the current
serial port communications settings of a stand-alone generator
or the ISA address of an -ISA model generator.
Other Required Cmds: None
E x a m p l e s : M O D E 9 6 0 0 N 8 1 H N / / S e t a s t a n d
/ / a l o n e g e n e r a t o r t o c o m m u n i c a t e
/ / a t 9 6 0 0 B a u d , N o p a r i t y , 8 d a t a
/ / b i t s , 1 s t o p b i t , R T S / / C T S
/ / h a n d s h a k i n g a n d N o p r o t o c o l
or
M O D E 2 4 0 0 / / C h a n g e o n l y t h e b a u d r a t e