Toshiba STRATA CIX User Manual
Page 68
Telephone Button Programming
300 Series Programs
1-64
Strata CIX/CTX Telephone Button Programming 11/04
312-01
DID Number
n =
up to seven digits
DID Number to be deleted.
313
Caller ID Assignment
313
,
Hold
This program assigns Caller ID circuits to the CO Line to which the
circuit is connected. The ANI, DNIS, DID formats for TI and analog
DID CO Lines are also defined.
313-00
Trunk Number
n,
Hold
,
n =
1~64 (CTX100)
1~96 (CTX670 Basic)
1~264 (CTX670 Exp.)
Enter the Trunk Number.
313-01
Signalling Method
FB01
, n,
Hold
n =
1.
None (default)
2.
ANI/DNIS-MCI
3.
ANI/DNIS-Sprint
4.
CLASS (Caller ID)
Specify the format for the interface being used.
313-02
Signalling Contents
FB02
, n,
Hold
n =
1.
ANI and DNIS (default)
2.
ANI only
3.
DNIS only
4.
DID only
Specify the contents of the ANI/DNIS format.
313-03
CLASS Equipment
Position
FB03
, xxyyzz,
Hold
xx =
Cabinet 01 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
If the CLASS type is chosen, the trunk must be assigned to a Caller
ID circuit. Enter the RCIU/RCIS equipment number as xxyyzz.
Notes
•
CLASS equipment numbers are required when assigning a trunk
to a RCIU/RCIS circuit.
•
It can also be used to display the equipment location of existing
caller ID circuit to trunk assignments. Example: If the trunk should
be connected to a caller ID circuit (RCIU/RCIS) in cabinet shelf 5,
slot 2, circuit 3, enter 050203.
yy =
Slot 01~8 (CTX100),
01~10 (CTX670)
zz =
Circuit 01~08
315
T1 Trunk Card
313
,
Hold
This command assigns T1 Trunk Card Data to the system.
315-00
T1 Equipment
Location
xxyy,
Hold
xxyy
xx = Cabinet 01,
yy = slot 01, 03, 05, or 07
Enter the RDTU PCB equipment location as xxyy:
Example: If the RDTU is installed in cabinet shelf 5, slot 3, enter
0503.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each
Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
Ö or xx = Cabinet 02~07,
yy = slot 01, 03, or 05
315-01
Coding Format
FB01
, n,
Hold
n =
1.
None
2.
PZC
3.
B8ZS (default)
4.
ZCS
Select the Coding Format.
315-02
Frame Format
FB02
, n,
Hold
n =
1.
None
2.
SF mode
3.
ESF mode (default)
Select the Frame Format.
315-03
Time Slots
n =
1.
None
2.
8 Time Slots (default)
3.
16 Time Slots
4.
24 Time Slots
Set the number of Time Slots to be used.
Table 1-28
Programs 303~315
(continued)
Button
Sequence
Value(s)
Summary