Toshiba STRATA CIX - Manual (Page 92)

Telephone Button Programming
500 Series Programs
1-88
Strata CIX/CTX Telephone Button Programming 11/04
570 Account Code Digit
Length
570 , Hold
Accounting Codes need to be specified for the number of digits that
are expected to be used for registering a number. This allows dialing
within Strata CTX to proceed automatically once the correct account
code is dialed. The following numbers are then dialed digits used for
making the phone call.
A second length is provided to allow the number of digits to be used
for verification of the code to be less than the total code entered; thus,
the code may contain two parts, one required and one part optional to
the user..
570-01 Verified Digit Length
FB01 , n, Hold
n = 4~15
(default = 4) The Verified Digit Length sets a number of digits to verify with a pre-
set list. This number may be the same or smaller than the account
code digits set to be entered for creating a complete accounting code.
Note This field is not changed, when ìProgram 506î on page 75
are registered.
570-02 Registered Digit
Length
FB02 , n, Hold , Hold
n = 4~15
(default = 6) The Registered Digit Length sets a number for the digits to be entered
to make a complete accounting code entry.
Note The Registered Digit Length ( FB02 ) must be greater than or
equal to the Verified Digit Length ( FB01 ).
571 Exception Numbers
for Forced Account
Codes
571 , Hold
Up to four telephone numbers can be programmed as exceptions to
the forced and /or verified account code entries (including 911).
These special codes enable numbers to bypass the verification
process and proceed unhindered.
571-01 Exception Number 1
FB01 , n, Hold
n = Up to 4 digits
Exception 1 default = 911
Exception 2~4 default = no
value
Enter a Forced Account Code Exception.
Note One of the assigned exception numbers should be 911.
Exception Numbers for Forced Account Code fields cannot
be duplicated.
571-02 Exception Number 2
FB02 , n, Hold
571-03 Exception Number 3
FB03 , n, Hold
571-04 Exception Number 4
FB04 , n, Hold , Hold
573 Delete Door Phone
573 , Hold
This command deletes door phone.
573-00 Door Phone
n, Hold , Hold
n = 1~6 (CTX100)
1~9 (CTX670 Basic)
1~24 (CTX670 Exp.) Enter the number of the door phone that is to deleted.
576 Door Phone Night
Ring Over External
Page
576 , Hold
This command assigns a Page Group to ring during system Night
Mode when a door phone button is pressed. The assignment can be
made independently for each Tenant.
576-00 Tenant Number
n, Hold
n = 1~2 (CTX100)
1~8 (CTX670) Select the system Tenant number to be assigned Door Phone to Page
Group/Night Ringing.
576-01 Page Group Number
FB01 , n, Hold , Hold
n = 0~4 (CTX100)
0~8 (CTX670 Basic)
0~16 (CTX670 Exp.)
(default = 0) Select the system Page Group number that should ring for the
selected Tenant when a door phone button is pressed during the
system Night Mode.
577 Caller History
577 , Hold
This command assigns which station stores Caller ID information for
PDN,CO,GCO and POOL line buttons
577-00 Circuit Type/Number
n, Hold
n = Up to 6 digits Enter the Circuit Type and number. See the Table 1-36 on page 89 .
577-01 Primary DN
FB01 , n, Hold , Hold
n = Up to 5 digits Enter Station DN to store call history data.
Table 1-35 Programs 500~577 (continued)
Button Sequence Value(s) Summary