Tektronix AWG610 - Manual (Page 197)

The Pattern Editor
AWG610 Arbitrary Waveform Generator User Manual
3-79
Table 3-24: Pattern editor bottom menu
Button Description
Tools Provides a command to convert pattern waveform data. This is the only
Tools command available while in the Pattern Editor.
The File Menu
The File menu command descriptions are the same as those for the Graphical
Waveform editor. Refer to The File Menu on page 3–48 for a description of the
File menu commands.
The Operation Menu
The Operation menu command descriptions are the same as those for the
Graphical Waveform editor except for Standard Waveform..., Vertical Shift...,
Vertical Scale..., and Clip..., which are not available in the Pattern Editor. Refer
to The Operation Menu section on page 3–50 for a description of the Operation
menu commands.
The Tools Menu
The only Tools command available in the Pattern Editor is the Code Convert...
command. This command creates a new pattern by using a user-specified table to
convert the pattern of the specified line. The instrument opens a new window to
display the results of the conversion.