Tektronix AWG610 - Manual (Page 455)

Appendix G: Sequence File Text Format
AWG610 Arbitrary Waveform Generator User Manual
G-3
Jump Table Definition. The 16 entries of the table definition follow the table jump
header TABLE_JUMP and a space, and must be delimited by comma (,):
TABLE_JUMP <space> <LLLL>, <LLLH>, <LLHL>, <LLHH>, <LHLL>,
<LHLH>, <LHHL>, <LHHH>, <HLLL>, <HLLH>, <HLHL>, <HLHH>,
<HHLL>, <HHLH>, <HHHL>, <HHHH>
Each of these entries must be:
<Entry>::= <Line Number> (range: 1 to 8000)
0 (No definition)
Logic Jump Definition. The 4 entries of the logic table definition follow the logic
jump header LOGIC_JUMP and a space, and must be delimited by comma (,):
Logic Jump <space> <Pin-0 logic>, <Pin-1 logic>,
<Pin-2 logic>, <Pin-3 logic>
<Pin-n logic>::= –1 (for X, don’t care),
0 (for L, low state) or
1 (for H, high state)
Jump Mode Selection. The jump table or logic jump definition you define is
effective depending on the jump mode setting as follows:
JUMP_MODE <space> <jump mode>
<jump mode>::= TABLE, LOGIC or SOFTWARE
Jump Timing and Strobe Settings.
JUMP_TIMING <space> <timing>
<timing>::= SYNC or ASYNC
STROBE <space> <strobe>
<strobe>::= 0 (for Off) or
1 (for On)