Tektronix AWG610 - Manual (Page 205)

The Pattern Editor
AWG610 Arbitrary Waveform Generator User Manual
3-87
Creating Standard Patterns
The counter dialog box lets you specify the type of pattern and the range (scope)
of data bits to apply to the pattern. See Figure 3–18. The instrument lets you
create one of four standard counter patterns as listed in Table 3–27, and inserts
the pattern in the edit area between the cursors.
Figure 3-18: Counter dialog box
Table 3-27: Patterns to be selected in Counter dialog box
Standard patterns Descriptions
Count Up Creates a binary incrementing counter pattern
Count Down Creates a binary decrementing counter pattern
Graycode Creates a gray code counter pattern
Johnson Creates a Johnson counter pattern
Do the following steps to create a counter pattern:
1. Specify the scope and area in which you want to create the pattern.
2. Push Operation (bottom)
!Counter... (pop-up). The Counter dialog box as
shown in Figure 3–18 is displayed.
3. Select a type (standard pattern) from the dialog box.
4. Specify the number of points in Points/Step in which you want to represent
one step of the standard pattern.
You may specify a value from 1 to 100 by using the general purpose knob or
numeric buttons.