Tektronix AWG610 - Manual (Page 232)

The Sequence Editor
3-114
AWG610 Arbitrary Waveform Generator User Manual
H When you set the value in the Repeat Count, the a and ' buttons are
assigned to shift the numeric values. To move the cursor horizontally, push
the TOGGLE or CLEAR MENU on the front-panel. Use the
a and ' button
to move the cursor.
H The side menu corresponding to the Data Entry bottom button varies with
the parameter value in the cursor position.
When you first open a new sequence table, a table containing 0 lines is created.
You must insert new lines into the table before you can edit the contents. To
insert new lines, use the Insert Line command as follows:
1. Move the cursor to the position that you want to insert a new line. If this is a
new table, you are already at the place to insert a new line.
2. Push Data Entry (bottom)
!Insert Line (side).
A new line is created immediately above the line of the current cursor
position.
If you insert a new line into a table that contains line jump numbers, the
instrument automatically updates the table line numbers and the jump line
numbers.
NOTE. The maximum number of lines in a sequence table is 8000.
You can cut a selected line to the paste buffer. Do the following steps to cut a
line:
1. Move the cursor to select the line that you want to delete.
2. Push Line Edit (bottom)
!Cut Line (side).
The instrument deletes the selected table line. You can use the Paste Line
command to insert the cut line into a new position in the table.
NOTE. After cutting a line from the table, the table automatically updates all
current and destination line numbers for jump operations. If you cut a line that
was specified as a jump destination, the jump setting is set to Off (no jump).
Reinserting the cut line will re-establish the jump connections.
You can copy a selected line to the paste buffer. Do the following steps to copy a
line:
Inserting a Line
Cutting a Line
Copying a Line