Tektronix AWG610 - Manual (Page 73)

Operating Basics
AWG610 Arbitrary Waveform Generator User Manual
2-35
Do the following steps to load a waveform file into the Setup screen:
1. Push the Waveform/Sequence bottom menu button.
This opens the Waveform/Sequence side menu.
2. Push the Load... side button. The instrument opens the Select File list as
shown in Figure 2–25.
Figure 2-25: Setup Waveform/Sequence menu
3. Use the general purpose knob or arrow buttons to select the file name to
load. If the file you want to load is located in a different drive or directory,
use the side menu buttons to change the current drive.
4. Push the ENTER front-panel button or OK side button. The instrument
loads the file and displays the file name in the selected channel file icon.
Push the Cancel side button to exit the file load process.
The procedures above explains how to load a waveform or pattern into the
waveform memory, and/or sequence file into the sequence memory, which will
be scanned to output. The waveform memory, sequence memory and the edit
buffer are completely independent. So, you can edit a waveform, pattern,
sequence or equation/text while outputting an another waveform or sequence.
However, when you push SETUP (front-panel)
!Waveform/Sequence
(bottom)
!Edit (side) to copy the waveform in the waveform memory to the edit
Loading a Waveform File
to Output