Tektronix AWG610 - Manual (Page 31)

Getting Started
AWG610 Arbitrary Waveform Generator User Manual
1-7
A 78 Mbyte flash disk addition. The hard disk is deleted when this option is
ordered.
The AWG610 Arbitrary Waveform Generator retains the state of the front panel
ON/STB switch. The ON/STB switch must be left in the on position to be able
to power on and power off the instrument using the principal power switch.
NOTE. If the ON/STB switch is left in the off position, you will not be able to
power on/off the instrument using the principal power switch or an external
power switch unit
Installation
Before installation, refer to the Safety Summary section at the front of this
manual for power source, grounding, and other safety information.
Verify that you have the correct operating environment.
CAUTION. To prevent damage to the instrument can occur if this instrument is
powered on at temperatures outside the specified temperature range.
The AWG610 Arbitrary Waveform Generator operates correctly in ambient
temperatures from +10
_ C to +40_ C and relative humidity from 20% to 80%. If
the instrument is stored at temperatures outside this range, do not switch on the
power until the chassis has come within the operating temperature range. For
more operating environment information, refer to Appendix B: Specifications on
page B–1.
NOTE. If you are installing the instrument in a rack, refer to the instruction sheet
that comes with the rack-mounting kit for proper installation procedures.
Verify that there is nothing blocking the flow of air at the fan and air intake
holes. The instrument exhausts air with the fan on its left side. Leave space at the
sides of the instrument so that the instrument does not overheat. The following
are the minimum space requirements for air flow around the instrument:
Rear 7.5 cm (3 in)
Left and right 15.0 cm (6 in)
Bottom 2 cm (0.8 in)
(The feet on the bottom of the instrument provide the required clearance
when set on a flat surface.)
Option 10 (78 Mbyte Flash
Disk)
Environment