Tektronix AWG610 - Manual (Page 270)

The UTILITY Window
3-152
AWG610 Arbitrary Waveform Generator User Manual
Displaying Instrument Status
Do the following steps to display the instrument software version and status of
the SCPI registers.
1. Push UTILITY (front-panel)
!Status (bottom)!System (side) to display
the instrument software version.
2. Push UTILITY (front-panel)
!Status (bottom)!SCPI Registers (side) to
display the current status of the SCPI registers.
Refer to the AWG610 Arbitrary Waveform Generator Programmer Manual for
the SCPI registers.
Internal Clock (Date and Time)
Do the following steps to set the date and time in the AWG610 Arbitrary
Waveform Generator:
1. Push UTILITY (front-panel)
!System (bottom).
2. Set the current year, month and day in the Year, Month and Day fields.
3. Set the current hour, minutes and seconds in the Hour, Min and Sec fields.
The changes are effective immediately.
Resetting the Instrument
The AWG610 Arbitrary Waveform Generator uses the Factory Reset and Secure
commands to reset the instrument.
Factory Reset resets the instrument to the factory settings at the time of
shipment. Some settings that are set in the UTILITY menu such as Network and
GPIB settings, are not reset when Factory Reset is initiated.
To perform the factory reset, do the following steps:
1. Push UTILITY (front-panel)
!System (bottom)!Factory Reset
(side)
!OK (side).
NOTE. Before pushing the OK side button, confirm that the data in the editor has
been saved to a file.
Factory Reset