Xilinx DS610 - Manual (Page 11)

Spartan-3A DSP FPGA Family: DC and Switching Characteristics
DS610 (v3.0) October 4, 2010 www.xilinx.com
Product Specification 11
General Recommended Operating Conditions
Table 7: General Recommended Operating Conditions
Symbol Description Min Nominal Max Units
T
J
Junction temperature Commercial 0 – 85
°C
Industrial –40 – 100
°C
V
CCINT
Internal supply voltage 1.14 1.20 1.26 V
V
CCO
(1) Output driver supply voltage 1.10 – 3.60 V
V
CCAUX
Auxiliary supply voltage (2) V
CCAUX
= 2.5 2.25 2.50 2.75 V
V
CCAUX
= 3.3 3.00 3.30 3.60 V
V
IN
(3) Input voltage PCI™ IOSTANDARD –0.5 – V
CCO
+0.5 V
All other
IOSTANDARDs IP or IO_# –0.5 – 4.10 V
IO_Lxxy_# (4) –0.5 – 4.10 V
T
IN
Input signal transition time (5) – – 500 ns
Notes:
1. This V
CCO
range spans the lowest and highest operating voltages for all supported I/O standards. Table 10 lists the recommended V
CCO
range specific to each of the single-ended I/O standards, and Table 12 lists that specific to the differential standards.
2. Define V
CCAUX
selection using CONFIG VCCAUX constraint.
3. See XAPP459 , Eliminating I/O Coupling Effects when Interfacing Large-Swing Single-Ended Signals to User I/O Pins on Spartan-3 Families.
4. For single-ended signals that are placed on a differential-capable I/O, V
IN
of –0.2V to –0.5V is supported but can cause increased leakage
between the two pins. See Parasitic Leakage in UG331 , Spartan-3 Generation FPGA User Guide.
5. Measured between 10% and 90% V
CCO
. Follow Signal Integrity recommendations.