Xantrex Technology XW - Manual (Page 77)

The XW Auto Gen Start Menu
975-0307-01-01 3–27
Multi-unit Config
“Multi-unit Config” provides the means to identify multiple units within
the same configuration.
Dev Name
The “Dev Name”, or Device Name, menu item gives each Xanbus-
enabled device a unique identifiable name. This makes each device easier
to identify when multiple Xanbus-enabled devices are connected together.
See the XW Inverter/Charger Operator’s Guide for additional
information.
Dev Number
The “Dev Number”, or Device Number, menu item gives each Xanbus-
enabled device a unique identifiable number in addition to the name. This
provides the means to use the same name, but different numbers for
similar devices (such as MPPT 01 and MPPT02).
See the XW Inverter/Charger Operator’s Guide for additional
information.
Connections
The “Connections” menu item identifies the AC and DC input and output
sources that affect or control the system (XW Auto Generator Start). Start
and stop triggers such as DC Voltage, charge stage, and AC load current,
are related to
these settings.
DC Conn The “DC Conn” (DC connection) must be set to match that of the XW
inverter/charter(s) in the system. This tells the XW Auto Generator Start
which battery bank to use for the charger based triggers. Configuration of
this parameter is only necessary for systems with more than one XW
inverter/charger and more than one battery bank.
AC In The “AC In” tells the XW Auto Generator Start what AC source or grid
the XW inverter/charger is connected to. The XW Auto Generator Start
uses this setting to stop the generator once the XW inverter/charger
transfers from the generator to the grid. Configuration of this parameter is
only necessary for larger systems with multiple XW inverter/charger and
multiple grid connections.
AC Out The “AC Out” tells the XW Auto Generator Start what load to monitor for
AC load triggers. Configuration of this parameter is only necessary for
systems with more than one XW inverter/charger.