Zoom MRS-1044 User Manual
Page 41
move-destination will be erased, and overwritten by the
move-source data. When this operation is completed, the
move-source region will contain silence.
1.
In the main screen, press the [PROJECT/UTILITY] key.
The display will indicate "PROJECT."
2.
Use the cursor [
E
]/[
R
] keys to make the display
read "UTILITY TR EDIT," and press the [ENTER] key.
The track edit menu will appear.
3.
Use the cursor [
E
]/[
R
] keys to make the display
read "TR EDIT MOVE," and press the [ENTER] key.
A screen will appear in which you can specify the move-
destination track and V-take.
4.
Use the dial and the cursor [
Q
]/[
W
] keys to specify
the move-source track and V-take.
In "TR xx-yy," "xx" specifies the move-source track
number, and "yy" specifies the V-take number. Use the dial
to select the track number (1 – 10), and use cursor
[
Q
]/[
W
] keys to select the V-take number (1 – 10).
If you turn the dial toward the right when track 10 is
selected, the following screen will appear.
In this screen you can use the dial to specify two adjacent
odd-numbered/even-numbered tracks (1/2, 3/4, 5/6, 7/8,
9/10) as the move-source. In this case, the V-takes
currently selected for the two selected tracks will
automatically be selected as the move-source.
5.
Press the [ENTER] key.
A screen will appear in which you can specify the starting
location of the move-source.
6.
Use the cursor [
E
]/[
R
] keys to move the blinking area
in the display, and turn the dial to specify the location.
The location can be specified in one of the following two ways.
• Specifying the location numerically
Move the blinking area to one of the M (minutes) / S
(seconds) / MS (millisecond) areas in the bottom of the
display, and turn the dial to edit the value of each unit.
• Assigning a previously-specified mark location
Move the blinking area to the MARKER area in the upper right
of the display, and turn the dial to specify the mark number.
• By pressing the [TIME BASE] key to switch to the
Measure display, you can specify the location in
measure/beat/clock units.
• By holding down STOP[
P
] and pressing the PLAY[
R
]
key, you can scrub-play the track and V-take you
specified in step 4. For details on using scrub-playback,
refer to p.31.
7.
When you have finished specifying the starting
location, press the [ENTER] key.
A screen will appear in which you can specify the ending
location of the move-source.
8.
Specify the ending location of the move-source in
the same way as in step 6.
At this time, you can press the PLAY[
R
] key to play back
the region between the specified starting location and
ending location. If there is no recorded data at the specified
ending location, an "*" symbol will appear in the lower line
of the screen.
9.
When you have finished specifying the ending
location, press the [ENTER] key.
A screen will appear in which you can specify the move-
destination track (and V-take).
H
INT
Move-source track
Move-destination track
Move
ZOOM MRS-1044
41
Refer
e
nce
[Recor
d
er]
Track editing