Zoom MRS-1044 - Manual (Page 46)

About the mixer
The mixer of the MRS-1044 is divided into two sections:
an "input mixer" that processes the input signals from the
[INPUT 1/2] jacks, and a "track mixer" that processes the
signals from the tracks of the recorder section and from the
rhythm section. Details of each mixer are described below.
■ Input mixer
In the input mixer you can adjust the sensitivity of the
signals that are input from the [INPUT 1/2] jacks, set
various parameters such as pan and send levels to the
send/return effects, and assign the signals to the recorder
tracks.
The parameters that can be adjusted in the input mixer are
listed in the following table.
■ Track mixer
In the track mixer you can process the playback signals of
the recorder tracks (1 – 6, 7/8, 9/10) and the sound of the
drum kit / bass program of the rhythm section, and mix
these signals to stereo. The signal mixed by the track mixer
is output via the MASTER fader from the [OUTPUT]
jacks.
In the track mixer, the signals that are output from each
track are handled in units called "channels." The
parameters that can be adjusted for each channel (DRUM,
BASS, 1 – 6, 7/8, 9/10) are listed in the table below.
The DRUM, 7/8, and 9/10 channels are each stereo
channels that respectively process the output signals from
the drum kit, stereo tracks 7/8, and 9/10. The parameters of
these stereo channels are linked.
H INT
Track 9/10
Track 7/8
Track 6
Track 5
Track 4
Track 3
Track 2
Track 1
BASS
DRUM
DRUM BASS MASTER 1 2 3 4 5 6 7/8 9/10
OUTPUT
Recorder
Rhythm section
Track mixer
Channel
Track 9/10
Track 7/8
Track 6
Track 5
Track 4
Track 3
Track 2
Track 1
Input mixer
INPUT
Recorder
ZOOM MRS-1044
46
Refer
e
nce
[Mixer]
This section explains the functions and operation of the two mixers built into the MRS-1044.
Reference [Mixer]
CHO SEND Volume sent to chorus/delay (send/return effect)
Volume sent to reverb (send/return effect)
Left/right position (L/R channel balance)
Volume of the input signal (position of the [REC LEVEL] control)
Content Parameter
REV SEND
PAN
REC LVL
EQ HI G
DRUM/BASS
Channel
7/8, 9/10 MASTER 1–6
EQ HI F
EQ LO G
EQ LO F
CHO SEND
REV SEND
PAN
FADER
ST LINK
Amount of boost/cut for high-range EQ
Frequency at which high-range EQ will boost/cut
Amount of boost/cut for low-range EQ
Frequency at which low-range EQ will boost/cut
Volume sent to chorus/delay (send/return effect)
Volume sent to reverb (send/return effect)
Left/right position (L/R channel balance)
Volume of each channel (fader position)
Link the parameters of the odd/even-numbered channels
Content Parameter
Input mixer parameters
Track mixer parameters