Zoom MRS-1044 - Manual (Page 77)

5. Turn the dial to change the setting to "DRY."
6. When you have finished adjusting settings, press
the [EXIT] key several times.
You will return to the main screen.
The "UTILITY REC SRC" setting is stored independently for
each project. Before you begin recording other parts,
change the setting back to "WET."
Here's how to select the patch for the insert effect.
1. Press the [EFFECT] key.
The [EFFECT] key will light, and a screen will appear in
which you can select a patch for the effect that you
operated last (either the insert effect or send/return effect).
The display will indicate the currently selected patch.
2. In the effect section, press the desired ALGORITHM
key.
• GUITAR/BASS algorithm: [GUITAR/BASS] key
• MIC algorithm: [MIC] key
• LINE algorithm: [LINE] key
• MASTERING algorithm: [MASTERING] key
When selecting a patch for the insert effect, you will begin
by first selecting the algorithm (the combination of effect
modules). When you press the ALGORITHM key, the
display will show the insert effect patches of that
algorithm.
3. Turn the dial to select the desired patch.
As you turn the dial, new patches will be recalled
immediately.
4. If you want to temporarily turn the insert effect off,
press the effect section [BYPASS/TUNER] key.
The [BYPASS/TUNER] key will light, and the insert effect
will be bypassed. Bypass will be disabled when you press
the [BYPASS/TUNER] key once again.
If you press the [ENTER] key after pressing the
[BYPASS/TUNER] key, the Tuner function will be turned on.
(For details on the Tuner function, refer to p.92.)
5. To return to the main screen, press the [EXIT] key.
The flow of the signal that passes through the insert effect
will change as shown below, depending on the insert
location, the number of input signal channels (1 or 2
channels), and the input/output type of the insert effect
(mono input / stereo output, or stereo input and output).
("M
→ S" indicates mono input / stereo output, and "S →
S" indicates stereo input/output algorithms.)
■ When inserted into the input mixer
• When recording on two mono tracks (tracks 1/2, 3/4,
5/6) or on a stereo track (7/8, 9/10)
INPUT 1
or
INPUT 2
INPUT 1
or
INPUT 2
INPUT 1
INPUT 2
INPUT 1
INPUT 2
Recorder
Recorder
Recorder
Recorder
Track
Track
Track
Track
Track
Track
Track
Track
EFFECT
( M → S )
EFFECT
( S → S )
EFFECT
( M → S )
EFFECT
( S → S )
H INT
INSERT: insert effect
S/R-REV: Send/return effect (reverb)
S/R-CHO: Send/return effect (chorus/delay)
Patch name Patch number
Selecting the patch for the insert
effect
N OTE
ZOOM MRS-1044
77
Refer
e
nce
[Ef
fects]
Using the insert effect