Zoom MRS-1044 - Manual (Page 76)

When the project is in its initial state, the insert effect is
sent into the input mixer. However, you may change the
insert location as necessary. The procedure is as follows.
1. In the main screen, press the effect section [INPUT
SOURCE] key.
The currently selected insert location will appear in the
display.
The display has the following significance.
• INPUT: Input mixer (default setting)
• DRUM: DRUM channel of the track mixer
• BASS: BASS channel of the track mixer
• TR 1 – TR6: Channels 1 – 6 of the track mixer
• TR1/2, TR3/4, TR5/6, TR7/8, TR9/10: Channels 1/2, 3/4,
5/6, 7/8, or 9/10 of the track mixer
• MASTER: Immediately before the MASTER fader
2. Turn the dial to select the insert location.
While the above screen is displayed, you can also select the
insert location by pressing an INPUT 1/2 [ON/OFF] key or a
status key (DRUM, BASS, 1 – 6, 7/8, 9/10, MASTER). When
using the status keys to select channels 1/2, 3/4, or 5/6 as a
pair, press status keys 1/2, 3/4, or 5/6 simultaneously.
3. Press the [EXIT] key.
You will return to the main screen.
If the [INPUT SOURCE] key is lit when you are in the main
screen, this means that the insert effect is placed in a
location other than in the input mixer.
Normally when the insert effect is placed into the input
mixer, the signal processed by the effect will be recorded on
the track. If necessary, however, you can apply the insert
effect only to the monitor signal, and record the unprocessed
input signal on the track. For example when recording the
unprocessed sound of a vocal performance, the vocalist will
be more comfortable singing if an insert effect suitable for
mic recording is applied to the monitor signal.
1. Send the insert effect into the input mixer.
For the procedure, refer to the preceding section.
2. Press the [EFFECT] key, and then press one of the
ALGORITHM keys that is already lit.
A screen will appear in which you can select an insert
effect patch.
3. Press the [PROJECT/UTILITY] key, and use the
cursor [ E ]/[ R ] keys to make the display read
"UTILITY REC SRC."
4. Press the [ENTER] key.
A screen will appear in which you can select one of the
following two types of signal to be recorded on the track.
• WET: The input signal that has passed through the insert
effect will be recorded on the track (default setting).
• DRY: Only the unprocessed input signal will be recorded
on the track. Even in this case, however, the insert effect
will be applied to the monitor signal.
INPUT
Insert effect
Recorder
Applying the insert effect only to the
monitor signal
H INT
H INT
Location at which the insert effect is inserted
Changing the insert location of the
insert effect
ZOOM MRS-1044
76
Refer
e
nce
[Ef
fects]
Using the insert effect