Zoom MRS-1044 - Manual (Page 50)

At this time, your editing will affect the channel that was
last selected in steps 2 – 3. As necessary, use the statue
keys or the cursor [ E ]/[ R ] keys to switch channels.
5. Use the cursor [ Q ]/[ W ] keys to select the EQ
parameter that you want to adjust, and turn the dial
to edit the value.
The parameters that can be selected and their ranges are as
follows.
■ If you pressed the [EQ HIGH] key first
• EQ HI G : Adjust the amount of high-range boost/cut.
Range: -12 – 0 – 12 (dB), Default: 0
• EQ HI F : Adjust the frequency at which the high-range
boost/cut will occur.
Range: 500 – 18000 (Hz), Default: 8000
■ If you pressed the [EQ LOW] key first
• EQ LO G : Adjust the amount of low-range boost/cut.
Range: -12 – 0 – 12 (dB), Default: 0
• EQ LO F : Adjust the frequency at which the low-range
boost/cut will occur.
Range: 40 – 1600 (Hz), Default: 125
• When the EQ HI G / EQ HI F screens are displayed, you
can press the [EQ HIGH] key to switch the high-range EQ
on/off. (The key will be dark when off.)
• When the EQ LO G / EQ LO F screens are displayed, you
can press the [EQ LOW] key to switch the low-range EQ
on/off. (The key will be dark when off.)
6. Repeat steps 4 – 5 to adjust settings in the same
way for another range or EQ parameter.
7. When you have finished adjusting settings, press
the [EXIT] key.
You will return to the main screen.
Here's how to adjust the effect depth by setting the volume
that is sent from each channel to the send/return effects
(chorus/delay, reverb).
1. Press the TRACK PARAMETER section [CHORUS/
DELAY SEND] key or [REVERB SEND] key to select
a send/return effect.
2. Press one of the status keys (DRUM, BASS, 1 – 6,
7/8, 9/10) to select the desired channel.
The corresponding channel will be selected for operations.
3. Turn the dial to edit the value.
The effect will apply more deeply as you increase the
value. The range and default setting of each parameter are
as follows.
• REV SEND : 0 – 100 (Default: 0)
• CHO SEND : 0 – 100 (Default: 0)
When the CHORUS/DELAY SEND or REVERB SEND
parameters are displayed, you can use the [CHORUS/
DELAY SEND] key or [REVERB SEND] key as an on/off
switch for the signal that is sent from that channel to the
reverb or chorus/delay. For details refer to p.48.
4. When you have finished adjusting settings, press
the [EXIT] key.
You will return to the main screen.
Adjacent odd-numbered → even-numbered mono channels
(1/2, 3/4, 5/6) can be linked. (This is referred to as "stereo
link.") The parameters of two stereo-linked channels will
operate in tandem in the same way as channels 7/8 or 9/10.
1. Press the TRACK PARAMETER section [PAN] key.
Linking odd-numbered/even-numbered
channels
H INT
Adjusting the effect depth
H INT
H INT
ZOOM MRS-1044
50
Refer
e
nce
[Mixer]
Basic operation of the track mixer