Zoom MRS-1044 - Manual (Page 80)

The following diagram shows an example of when the
MODULATION/DELAY module effect is changed from
"CHORUS" to "FLANGER."
Some effect modules have only one effect type. For such
modules, there will be no screen for selecting the effect
type.
If the contents of a patch have been edited, the "EDIT"
indicator in the upper part of the display will change to
"EDITED."
6. Use the cursor [ Q ]/[ W ] keys to select the effect
parameter that you want to edit.
The following diagram shows an example of what you see
when you have selected the DEPTH parameter of the
"FLANGER" effect.
7. Turn the dial to change the setting.
For details on the effect types that can be selected for each
effect module, and on the effect parameters of each type,
refer to the appendix ( → p.98) at the end of this manual.
8. Repeat steps 4 – 7 to make the desired edits for
other modules.
9. If you want to adjust the patch level (the final
volume of the patch), press the [TOTAL] key, use
the cursor [ Q ]/[ W ] keys to make the display read
"TOTAL PAT LVL," and turn the dial.
The patch level can be adjusted in a range of 1 – 30.
Strictly speaking, the patch level is not an effect module,
but is one of the parameters included in the patch.
10. When you have finished editing, press the [EXIT]
key.
You will return to the patch select screen.
Be aware that if you return to the patch select screen and
select another patch, the edited contents will be lost. If you
want to keep the results of your editing, refer to the
following section.
A patch you edited can be stored in any location of the
same algorithm. You can also store an existing patch in
another location to create a copy of that patch.
1. Press the [EFFECT] key, and then press the [EDIT]
key.
The currently selected patch can now be edited.
2. Press the [TOTAL] key, and use the cursor [ Q ]/[ W ]
keys to make the display read "STORE."
3. Press the [ENTER] key.
A screen will appear in which you can specify the store-
destination patch number.
4. Turn the dial to select the store-destination patch
number, and press the [ENTER] key.
The display will ask "SURE?"
5. Press the [ENTER] key.
The patch will be stored, and you will return to the patch
select screen.
Storing an insert effect patch
N OTE
H INT
Patch level
Effect parameter Setting
H INT
N OTE
Effect type
ZOOM MRS-1044
80
Refer
e
nce
[Ef
fects]
Using the insert effect