Zoom MRS-1044 - Manual (Page 73)

5. When you have finished creating settings, press the
[EXIT] key several times.
You will return to the main screen.
You can change the length of the pre-count that is sounded
when you record a rhythm pattern. When the following
screen is displayed, turn the dial to choose one of these
settings.
• OFF: The pre-count will be turned off.
• 1: A one-measure pre-count will be sounded (default
setting).
• 2: A two-measure pre-count will be sounded.
• PAD: The pre-count will be turned off, and recording
will begin the instant you tap a pad.
You can change the volume of the metronome that sounds
while you record a rhythm pattern. When the following
screen is displayed, turn the dial to adjust the volume (0 –
15).
You can specify how the volume will respond to the force
with which you tap the pads (pad sensitivity). When the
display indicates "PAD SENS," turn the dial to select one
of the following settings.
• SOFT: The volume will be soft, regardless of how
strongly you tap.
• MEDIUM: The volume will be medium, regardless of
how strongly you tap.
• LOUD: The volume will be loud, regardless of how
strongly you tap.
• LITE: Maximum sensitivity. Even light taps will produce
a loud volume.
• NORMAL: Normal sensitivity (default setting).
• HARD: Low sensitivity.
• EX HARD: Lowest sensitivity. Loud volumes will not be
produced unless you tap quite strongly.
The remaining amount of recording memory for rhythm
patterns and the rhythm song will be displayed as a
percentage (%). This screen is for display only, and has no
setting that can be edited.
Checking the remaining amount of
memory (MEMORY)
Adjusting the sensitivity of the pads
(PAD SENS)
Changing the metronome volume
(CLICK)
Changing the length of the pre-count
(COUNT)
ZOOM MRS-1044
73
Refer
e
nce
[Rhythm]
Editing various settings of the rhythm section