Zoom MRS-1044 - Manual (Page 42)

10. Specify the move-destination track and V-take in
the same way as in step 4.
A screen will appear in which you can specify the move-
destination location.
11. Specify the move-destination location in the same
way as in step 6, and press the [ENTER] key.
A screen will appear in which you can specify the number of
times (1 – 100) that the move-source region will be copied.
12. Turn the dial to specify the number of times that
the data will be copied, and press the [ENTER] key.
The display will ask "TrMove SURE?," asking you to
confirm the Move operation.
13. To execute the Move operation, press the [ENTER]
key. To cancel, press the [EXIT] key.
When you press the [ENTER] key and the Move operation
is completed, the display will indicate "COMPLETE." If
you then press the [EXIT] key, you will return to the Track
Edit menu of step 2.
If you press the [EXIT] key in step 13, you will return to
the setting screen of step 11. If necessary, you can press the
[EXIT] key repeatedly to step back through each setting
screen.
This operation erases the recorded data from the specified
region, returning it to a silent (blank) state.
1. In the main screen, press the [PROJECT/UTILITY] key.
The display will indicate "PROJECT."
2. Use the cursor [ E ]/[ R ] keys to make the display
read "UTILITY TR EDIT," and press the [ENTER]
key.
The Track Edit menu will appear.
3. Use the cursor [ E ]/[ R ] keys to make the display
read "TR EDIT ERASE," and press the [ENTER] key.
A screen will appear in which you can specify the track
and V-take from which data will be erased.
4. Use the dial and the cursor [ Q ]/[ W ] keys to specify
the track and V-take from which data will be
erased.
In "TR xx-yy," "xx" is the track number and "yy" is the V-
take number from which data will be erased. Use the dial to
select the track number (1 – 10), and use the cursor
[ Q ]/[ W ] keys to select the V-take number (1 – 10).
If you turn the dial toward the right when track 10 is
selected, the following screen will appear.
In this screen you can use the dial to specify two adjacent
odd-numbered/even-numbered tracks (1/2, 3/4, 5/6, 7/8,
9/10). In this case, data will be erased from the V-takes
currently selected for the two selected tracks.
5. Press the [ENTER] key.
A screen will appear in which you can specify the starting
location of the region that will be erased.
6. Use the cursor [ E ]/[ R ] keys to move the blinking
area in the display, and turn the dial to specify the
location.
The location can be specified in one of the following two
ways.
• Specifying the location numerically
Move the blinking area to one of the M (minutes) / S
(seconds) / MS (millisecond) areas in the bottom of the
display, and turn the dial to edit the value of each unit.
• Assigning a previously-specified mark location
Move the blinking area to the MARKER area in the upper
right of the display, and turn the dial to specify the mark
number.
Erase
Erasing a specified region
ZOOM MRS-1044
42
Refer
e
nce
[Recor
d
er]
Track editing