7 write language preference +wlpw, 1 description, 2 syntax – Rainbow Electronics 900 User Manual
Page 178: 3 defined values, 8 read gpio value +wior, Write language preference +wlpw, Read gpio value +wior
FLYFOT-M260-MODULE
Page: 178 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
36
Icelandic
18.7 Write Language Preference +WLPW
18.7.1 Description
:
Write a Language Preference value in EF-LP
18.7.2 Syntax :
Command syntax: AT+WLPW=<index >,<value>
Response syntax: OK or +CME ERROR: <err>
18.7.3 Defined
values
:
<index>:
offset in the available languages range (SIM dependant).
<value>
See <value> examples above.
18.8 Read GPIO value +WIOR
18.8.1 Description
Read the requested GPI or GPIO pin value.
z
Note : by default (e.g. after a reset), the I/O ports configuration is set by the +WIOM command.
z
This command is allowed only on a Gpio not allocated by an Open-AT embedded application or
for bus operations.
18.8.2 Syntax
Command syntax: AT+WIOR=<index>
Response syntax: +WIOR: <value>
18.8.3 Defined
values
<index>
Eight I/O ports are available. The <index> value is between 0 and 7.