Rainbow Electronics 900 - Manual (Page 25)

FLYFOT-M260-MODULE
Page: 25 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged
without prior written agreement.
4.22.3 Defined values :
Operation:
0:turn off the led
1:flash the led according to the other parameters
light time in idle:
0~65535 the light time in idle state;
dark time in idle:
0~65535 the dark time in idle state;
light in calling:
0~65535 the light time in calling state;
dark in calling:
0~65535 the dark time in calling state;
mode:
0:Normal mode
1:Super mode(the flash of the led is not relative to the calling of registeration state)
4.23 Restricted SIM access +CRSM
4.23.1 Description
By using this command instead of Generic SIM Access +CSIM TE application has easier but more
limited access to the SIM database. This command transmits to the MT the SIM <command> and its
required parameters.
As response to the command, MT sends the actual SIM information parameters and response data. MT
error result code +CME ERROR may be returned when the command cannot be passed to the SIM,
but failure in the execution of the command in the SIM is reported in <sw1> and <sw2>
parameters.
As for the CSIM command , there is no locking between two successive commands. The user should
be aware of the precedence of the GSM application commands to the TE commands.
4.23.2 Syntax
Command Possible responses
+CRSM=<command>[,<fileid>
[,<P1>,<P2>,<P3>[,<data>]]]
+CRSM:
<sw1>,<sw2>[,<response>]
+CME ERROR: <err>
AT+CRSM? OK
AT+CRSM=? OK
4.23.3 Defined values
<command> : integer type
Command passed on by the MT to the SIM; refer GSM 11.11 (or 3GPP TS 51.011) :
176 READ BINARY
178 READ RECORD
192 GET RESPONSE
242 STATUS
all other values are reserved and the command will return +CME ERROR=3