Rainbow Electronics 900 - Manual (Page 45)

FLYFOT-M260-MODULE
Page: 45 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
AT+COPS=0
Note : Ask for registration on home
network
OK
Note : Succeeded
AT+COPS=3,0
Note : Set <format> to long
alphanumeric OK
Note: Succeeded
AT+COPS=2
Note : Ask for deregistration from
network
OK
Note : Succeeded
AT+COPS
+CME ERROR: 3
Note : not support
6.2.3 Defined values :
The parameters values are the following ones:
<mode>
0: automatic (default value)
1: manual
2: deregistration ; ME will be unregistered until <mode>=0 or 1 is selected.
3: set only <format> (for read command AT+COPS?)
4: manual / automatic (<oper> shall be present), if manual selection fails, automatic mode is entered.
<format>: format of <oper> field
0: long alphanumeric format <oper>
1: short alphanumeric format <oper>
2: numeric <oper> (default value)
<stat>: status of <oper>
0: unknown
1: available
2: current
3: forbidden
<oper>: operator identifier (MCC/MNC in numeric format only for operator selection)
The long alphanumeric format can be up to 16 characters long (see appendix 19.12 for operator names
description, field is “Name”)
The short alphanumeric format can be up to 8 characters long.
6.3 Network registration +CREG
6.3.1 Description
This command is used by the application to ascertain the registration status of the product.