Rainbow Electronics 900 - Manual (Page 224)

FLYFOT-M260-MODULE
Page: 224 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
18.47 FLYFOT Hang-up +WATH
18.47.1 Description
This specific command is used by the application to disconnect the remote user, specifying a release cause
and the location. In the case of multiple calls, all calls are released (active, on-hold and waiting calls).
18.47.2 Syntax
Command Syntax AT+WATH=<RelCause>,<location>
AT+WATH=31
OK
Note : Ask for disconnection with release Note : Every call, if any, are released
cause=normal and location=USER
AT+WATH=? +WATH: (1-127),(0-5,7,10)
AT+WATH=17,2 OK
Note : Ask for disconnection with release Note : Every call, if any, are released
cause=user busy and location=public
network serving the local user
18.47.3 Defined values
<RelCause> :
decimal value from 1 to 127 (see the table in appendix 18.4 “Failure Cause
from GSM 04.08 recommendation)
<location> :
optional parameter (default value =0)
values as defined in 04.08
0 : user
1 : private network serving the local user
2 : public network serving the local user
3 : transit network
4 : public network serving the remote user
5 : private network serving the remote user
7 : international network
10 : network beyond interworking point
Notes :
“AT+WATH=0” has the same behaviour as “ATH”
18.48 Write IMEI +WIMEI
18.48.1 Description
The download of the IMEI is available through this specific command. This operation is possible