Rainbow Electronics 900 - Manual (Page 94)

FLYFOT-M260-MODULE
Page: 94 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
10.3.2 Syntax :
Command Syntax: AT+CPWD=<fac>,<OldPassword>, <NewPassword>
Command
Possible responses
AT+CPWD = SC,"1234","4321"
Note: to perform this the pin lock must be active. +CME ERROR: 3
Note: operation not allowed
AT+CLCK=”SC”, 1, ”1234”
AT+CPWD = "SC","1234","4321" OK
AT+CPWD = "P2","12345678","87654321" +CME ERROR: 3
10.3.3 Defined values :
<fac>
see +CLCK command with only “P2” facility added (SIM PIN2).
Note : Whatever the facility specified, the change of password applies to all calls barring.
<OldPassword>, <NewPassword>
The password code is over up to 8 digits for P2 facility (4 to 8 digits).
The password code is over up to 4 digits for the other facilities (1 to 4 digits).
10.4 Call waiting +CCWA
10.4.1 Description:
This command allows control of the call waiting supplementary service. Activation, deactivation and status
query are supported. Parameter <n> is used to disable/enable the presentation of an unsolicited result code
+CCWA: <number>, <type>, <class>[, <alpha>] to the TE when call waiting service is enabled. Command
should be aborted when network is interrogated.
.
10.4.2 Syntax:
Command Syntax : AT+CCWA=<n>, [ <mode> [, <class> ] ]
Response Syntax: (for <mode>=2 and command successful)
+CCWA: <status> [, <class1> [ <CR><LF>+CCWA: <status>, <class2> [ … ] ]
Unsolicited result: +CCWA: <number>, <type>, <class> [, <alpha>] (when waiting service is enabled)
Command
Possible responses
AT+CCWA =1,2
Note: Query enable status +CCWA: 1,1
OK
Note: voice call waiting is active
AT+CCWA =1
Note: enable the presentation of an unsolicited OK