Rainbow Electronics 900 - Manual (Page 213)

FLYFOT-M260-MODULE
Page: 213 / 239
This document is the sole and exclusive property of FLYFOT. Not to be distributed or divulged without
prior written agreement.
Note :
If no embedded application is loaded, the<ExtVersion>parameter does not appear.
18.41 FLYFOT Reset +WRST
18.41.1 Description
This specific command resets the module after the time specified by the <delay> parameter.
18.41.2 Syntax
Command syntax : AT+WRST =<Mode>,<Delay>
Response syntax : +WRST: <Mode>,<Delay>,<RemainTime>
Command Possible responses
AT+WRST=? OK
AT+WRST=0 OK
Note : Disable timer
AT+WRST=1,”001:03” OK
Note : Enable timer and set delay at 1
hour 3 minutes
AT+WRST? +WRST: 1,”001:03”,”001:01” OK
Note: Timer activated to reset after 1
hour and 3 minutes. At this point, 1 hour and 1
minute remain before next reset.
18.41.3 Defined values :
<val1> :
0 : timer reset is disabled
1 : timer reset is enabled
<Delay>: sets the time before reset
Range “000:01”- “168:59” (format hhh:mm)
<RemainTime> : time before next reset
Range “000:01”- “168:59” (format hhh:mm)
18.42 Set Standard Tone +WSST
18.42.1 Description :
This specific command allows to set/get the sound level of the Standard Tones.