Alpha Technologies AMP24 HP - Manual (Page 50)

Doc. #: 0260011-J0 Rev B 48
21. Use the CXCU GUI as follows to verify that the modules are recognized and the voltages and
currents of the modules are displayed. (Ignore any alarms at this point. The current readings at
no load are not very precise.)
a. Select Inverters > View Live Status.
b. In the Inverter Report screen, locate the module for AC phase 1 by clicking each row until
the LEDs of the inverter, in the first phase 1 shelf, flash for a few seconds.
c. Using the pull down box in the Module Number column, set the module number to 1 to
correspond to AC phase 1.
d. If this is a multiple phase system,locate the module for AC phase 2 by clicking each row in
the Inverter Report screen until the LEDs of the inverter, in the first phase 2 shelf, flash for a
few seconds.
e. Use the pull down box to set the module number to 2 to correspond to AC phase 2 (for split
phase, 2-pole and 3 phase systems).
f. Repeat for a third module (select 3 to correspond to AC phase 3) if the system is 3 phase.
Figure 30 — Inverters > View Live Status
e
a
step
b
step
c
step
d step
step